Section 1 - General Information
Introduction
Identifying Your Machine
1-4
1-4
9813/4600-1
Component Identification Plates
Typical Engine Identification Number
The engine data label is located on the top of the engine.
If the engine is replaced by a new one, the data plate serial
number will be wrong.
Either stamp the new number on the plate or stamp out the
old one. This will prevent the wrong number being quoted
when you order replacement parts.
a
Engine Model
b
Engine Serial Number
c
EU Approval Code
d
Specification Number
e
RPM
C089970-C10
Fig 4.
Emission Control Information
The data plate which shows the EPA regulations is on the
rocker arm cover.
1
Power Category
2
Engine Displacement
3
EPA Family ID
4
Tune-up Specifications: Injection Timing
5
Tune-up Specifications: Injection Opening Pressure
6
PM
7
Fuel Type
C089970-C2
Fig 5.
ROPS Data Plate
!M
WARNING
You could be killed or seriously injured if you operate
a machine with a damaged or missing ROPS/FOPS. If
the Roll Over Protection Structure (ROPS)/Falling
Objects Protection Structure (FOPS) has been in an
accident, do not use the machine until the structure
has been renewed. Modifications and repairs that are
not approved by the manufacturer may be dangerous
and will invalidate the ROPS/FOPS certification.
INT-2-1-9_6
!M
WARNING
Seat Belts
The ROPS/FOPS is designed to give you protection in
an accident. If you do not wear your seat belt, you
could be thrown out of the machine and crushed. You
must wear a seat belt when using the machine. Fasten
the seat belt before starting the engine.
0153
c
d
b
e
a
4
7
6
2
1
3
5