jcb 516-40 TIER 3, Operator'S Manual

Page: 24 / 31

Introduction
Safety Check List
11 11
9821-9750-2
!M
DANGER
Forks/Working Platform
Using the forks alone as a working platform is
hazardous; you can fall off and be killed or injured.
Never use the forks as a working platform.
5-1-5-3
!M
WARNING
Forks/Turning
The forks project in front of the machine. Make sure
there is enough clearance for the forks when making
turns.
5-1-5-4_2
!M
WARNING
High Loads
A high load can block your view and reduce the
machine's stability. Travel with the load low to the
ground. Travel slowly and with caution over rough,
muddy or loose surfaces.
5-1-3-2
!M
WARNING
Slopes
When transporting a load on a slope, drive slowly and
keep the load uphill of the machine. This will increase
stability.
5-1-4-1
!M
WARNING
Hillsides
Operating the machine on hillsides can be dangerous
if proper precautions are not taken. Ground conditions
can be changed by rain, snow, ice etc. Check the site
carefully. Operate in first gear on hillsides, when
applicable, keep all attachments low to the ground.
Never coast down a hill with the engine off or the
transmission in neutral.
INT-2-2-7
!M
WARNING
Visibility
Accidents can be caused by working in poor visibility.
Use your lights to improve visibility. Keep the road
lights, windows and mirrors clean.
Do not operate the machine if you cannot see clearly.
5-1-4-7
!M
WARNING
Keep Your Hands and Feet Inside the Vehicle
When using the machine, keep your hands and feet
clear of moving parts. Keep your hands and feet within
the operator compartment while the vehicle is in
motion.
13-1-1-17
!M
WARNING
Controls
You or others can be killed or seriously injured if you
operate the control levers from outside the machine.
Operate the control levers only when you are correctly
seated.
0179_2
!M
CAUTION
Passengers
Passengers in or on the machine can cause accidents.
Do not carry passengers.
INT-2-2-2_1
!M
WARNING
Fires
If your machine is equipped with a fire extinguisher,
make sure it is checked regularly. Keep it in the correct
machine location until you need to use it.
Do not use water to put out a machine fire, you could
spread an oil fire or get a shock from an electrical fire.
Use carbon dioxide, dry chemical or foam
extinguishers. Contact your nearest fire department as
quickly as possible. Firefighters should use self-
contained breathing apparatus.
INT-3-2-7_2