16
21-AG125
Instruction & User Manual
m
Once a cut has begun and a notch is
established in the workpiece, do not change
the angle of the cut. Changing the angle of
the cut will cause the wheel to bend and
may cause wheel breakage. Edge grinding
wheels are not designed to withstand side
pressures caused by bending.
Do not use edge grinding/ cutting wheels for
surface grinding applications. These wheels
are not designed for side pressures encoun-
tered with surface grinding - wheel breakage
and injury may result.
WARNING!
Surface Finishing with Sanding Flap
Discs
m
Maintain a 5-10 degree angle between the
disc and work surface
m
Continuously move the disc in a forward
and back motion to avoid creating gouges in
the work surface.
Maintenance
Switch off the tool and disconnect the power
(remove battery/unplug) before cleaning and
maintenance. This helps avoid the risk of
electric shocks and accidental starting.
WARNING!
m
Wipe the tool with a dry or damp cloth.
Do not use a wet cloth.
Do not use
detergent that contains solvent or
corrosive, abrasive additives.
This risks
damaging the surfaces of the tool.
m
Clear the tool vents and the accessory
mount of dust and dirt after each use.
Do not clean ventilation holes by
inserting sharp objects in them, such
as screwdrivers and other similar
objects.
m
Stubborn contamination in areas hard to
access can be removed with compressed air
(max 3. bar).
m
Regularly check all fasteners, screws and
bolts to make sure that they are tight.
Tighten any loose screws immediately or
serious injury could occur.
m
If the power cord becomes damaged and
replacement is necessary, this must be
carried out by an authorised warranty agent.
Never open the tool. The tool has no
internal parts that the user can service or
repair. Never try to repair the tool yourself.
Take to an authorised service centre.
WARNING!
Transport and Storage
m
If the tool will remain unused for any length
of time, it should be stored in the original
packaging.
m
Store the tool in a dry, frost-free, well
ventilated place.
m
Keep all tools out of the reach of children.
m
Always switch off the tool and disconnect it
from the power supply (remove the battery/
unplug the power cord) before transport.
m
Always carry the tool using the purpose-
designed handle.
