JC BORDELET CALISTA 917, Instruction Manual

Page: 2 / 15

TECHNICAL INFORMATION
It is necessary to comply with all national regulations,
especially those referring to national and European standards,
when installing the appliance.
JC BORDELET recommends installing the appliance at a
minimum distance of 100 mm from non-combustible walls to
ensure good efficiency of the appliance and facilitate
assembly.
Since this appliance is airtight, connection to outside air can
be made either through a triple wall flue duct or by direct
connection through a connection kit.
For any direct connection to the outside air, it is mandatory to
ensure that the inlet sections are sufficient according to their
length and re-routing.
In case of installation of a triple wall flue duct connection, the
installation instructions and precautions found in the
Technical Application Document of said duct should be
complied with, in addition to these instructions. Minimum flue
height needed for proper appliance operation is 4.5m.
This appliance must not be installed on a smoke duct or an
air supply serving another appliance.
Exhaust fans in the same room or space as this appliance
may cause operating problems. (backdraft of smoke, variable
combustion rate). The compatibility of the appliance with any
exhaust fan should be ensured.
Exhaust fans have no impact on combustion if the
combustion air inflow is ducted, the air is drawn from outside
the building, the door(s) are properly locked, and all the air
seals are not deteriorated.
The appliance must be suspended according to the
recommendations of JC BORDELET based on the information
given and validated by the installer.
It is necessary to provide an access for cleaning the
appliance, the connection duct and the smoke duct.
Place any air intake grille in such a way that it cannot be
obstructed.
A minimum distance of 1000 mm between the unit and any
combustible material should be maintained when the latter is
pivoting. For all other configurations, refer to the following
page
For reasons of space, all our appliances are delivered in
separate components. The assembly must be carried out in
accordance with this installation manual and according to the
drawing provided by JC BORDELET after study of the
installation.
During installation, it is advisable to leave the protection
devices present on the appliance and to remove them only
after all the assembly operations are completed.
The actual definitions of certain parts described in this
manual may change without affecting the installation and/or
operation.