JBL VTX Series, Manual

Page: 43 / 78

43
VTX A 12 | Rigging Manual
STEPS:
• With the VTX A12 VT secured by all four quick release pins, lower the array until the VT’s front wheels touch the ground. The
array will roll backwards slightly and, as the array is lowered, the angles of the bottom four cabinets will close to the 10-degree
position.
• Once the bottom five cabinets close together, set the angle selection quick release pins on the bottom four VTX A12 cabinets
to the 10-degree storage position.
• Close all Locking levers by pressing each one forward until it clicks closed and is completely flush with the rear of the cabinet.
• Remove the rear quick release pins between the fourth and fifth cabinets up from the ground. These quick release pins should
move easily, as the weight of the array is being held by the front wheels of the Vertical Transporter resting on the ground.
• Raise the array back up and allow the four VTX A12 cabinets on the Vertical Transporter to roll forward until the cart is resting
safely on all four wheels. Stop lifting the array when the A12 cabinets on the VT reach this position. At this point, remove the
front attachment quick release pins from the VTX A12 cabinets. They will slide out of their attachment receptacles easily, sep-
arating the suspended VTX A12 array from the stacked cabinets on the Vertical Transporter cart.
10.2 CLOSE THE ANGLE LOCKS AND MOVE PINS TO STORAGE
1
2
3
4
5
1
2
3
4
5