10
PROTECTIVE JACKET INSTALLATION
Complies with IEC 60529 - IPX-3, not evaluated for outdoor use
1. Remove two protective jackets from the protective jacket kit.
To install, open the jacket by “unzipping” the Velcro strip and
locate two smaller Velcro tabs on the inside of the jacket. See
Figure 2
2. Open the center Velcro tab and insert through the opening in
the module riser. See Figure 3
3. Next, wrap the left side of the cover around the bottom edge
of the riser. Insure that the bottom of the jacket is tucked into
the riser ring crevice between the top of the chassis and the
bottom of the riser ring rim. See Figure 4.
4. Pull the second Velcro tab through the second opening in the
riser ring. See Figure 4
Figure 3
Figure 4
Figure 2
