JBL Stage XD-5, Quick Start Manual

Page: 2 / 2

European Representative: Harman International Industries, Incorporated.
EMEA Liaison Office, Danzigerkade 16G, 1013 AP Amsterdam, The Netherlands.
UK Business Address: Ground Floor, Westside 2, London Road, Apsley, Hemel Hempstead, Hertfordshire, HP3 9TD, United Kingdom.
© 2022 Harman International Industries, Incorporated. All Rights Reserved.
JBL is a trademark of Harman International Industries, Incorporated registered in the United States and other countries.
Features, Specifications, and Appearance subject to change without notice.
Stage XD Indoor/Outdoor Speakers Quick Start Guide | Rev 1.1 20220808 | Part No. 950-0608-001
Wall Installation
The Stage XD speaker can be installed on a wall using the included Wall Installation Hardware. Follow the instructions carefully to ensure
proper installation.
1. Install lock nut
[A] onto threaded knuckle [C] away from the end.
2. Slide lock ring [B] over threaded knuckle [C] .
3. Secure lock nut [A] onto speaker.
4. Locate mounting position on wall leaving enough space for speaker to clear ceiling and/or other obstacles. Secure knuckle joint [D] to
wall with the included security cable
[E]
on one of the bottom screws.
5. Install the knuckle [C] into the joint [D] and secure lock ring [B] .
A A A
A A
B B
C C
A
B
C
B B D D
EE
B D
E
Adjusting Angle and/or Orientation
Once the speakers are installed on the wall they can be adjusted for angle and orientation. Simply loosen the lock ring slightly and move the
speaker within the mount into the desired orientation. Note that for horizontal orientation the logo can be rotated.
Tabletop Installation
While the common use is to install Stage XD speakers onto a wall,
they can also be used on a table/desktop. To use on a flat surface,
install the included rubber feet onto the bottom of each speaker at
the rear outer corners.
Feet Location Feet Location
Feet Location
Connecting Speakers
1. Ensure that the appropriate wire gauge has been run based the
Wire Gauge by Distance chart.
2. Ensure that wires are marked for polarity to ensure speakers are
not connected out of phase.
3. Connect positive wires to the (+) terminal and negative feed wire
to the (-) terminals.
4. Continue connecting until all speakers are connected.
Specifications
Stage XD-5 Stage XD-6
High Frequency
Transducer
1" (25mm) Aluminum
dome with High-
Definition Imaging
(HDI™) waveguide
1" (25mm)
Aluminum dome
with High-Definition
Imaging (HDI™)
waveguide
Low Frequency
Transducer
5.25" (130mm)
Polycellulose cone
woofer 6.5" (165mm)
Polycellulose cone
woofer
Nominal Impedance 4ohms 4ohms
Sensitivity
(2.83V@1m)
86dB 88dB
Recommended
Amplifier Power
20-100W RMS 20-100W RMS
Frequency Response
(-6dB On-Axis)
75Hz-25kHz 55Hz-25kHz
Crossover Frequency 2500K 2500K
Dimensions HxWxD
H: 6.4 (162mm) x
W: 7.2 (182mm) x
D: 6.4 (162mm) H: 8.7 (222mm) x
W: 11.8 (299mm) x
D: 7.6 (194mm)
Wall Mount Length H: 2.8 (71mm) H: 2.8 (71mm)
Harman International Industries, Incorporated.
8500 Balboa Blvd, Northridge CA 91329 United States.