4
Important Safety Note:
The
customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speaker,
and for proper assembly
and installation of the wall-
bracket, including but not
limited to the selection of
appropriate weight-bearing
supports and proper use of
the bracket. JBL disclaims
any liability for the selection
of mounting hardware and/or
bracket installation. Be sure
to follow these bracket
assembly and installation
instructions carefully. If you
have any questions or doubts
about your ability to correctly
wall-mount the speakers,
consult with your authorized
JBL dealer or custom
installer.
Step 1: Unscrew and remove
the large
Molded Nut
™
. If
necessary, use the supplied
Metal Bar
∞
as a lever by
inserting it into one of the
holes in the outer edge of the
Molded Nut
™
.
Step 2: Firmly grasp the
Ball
and Shaft
£
and pull it
straight out of the
Attach-
ment Plate
¢
. Avoid leaning
it to the side for leverage, as
this may break off a tab.
Step 3: Slide the
Molded Nut
™
onto the
Ball and Shaft
£
with the threaded opening
facing the ball. Thread the
Metal Nut
¡
all the way
onto the
Ball and Shaft
£
,
with the star washer side
away from the ball. Refer to
the exploded drawing for the
proper orientation of these
three parts.
Step 4: Screw the
Ball and
Shaft
£
into the
Threaded
Insert
§
on the back of the
Satellite Speaker
¶
until
it is fully seated in the
Threaded Insert
§
, but
do
not
tighten as you might dis-
lodge the
Threaded Insert
§
.
Such damage would
not be covered under the
warranty.
Step 5: Tighten the
Metal Nut
¡
with the star washer side
between the
Metal Nut
¡
and the back of the
Satellite
Speaker
¶
, using large
needle-nose pliers until it is
firmly seated against the
back of the
Speaker
¶
and
has locked the
Ball and Shaft
£
and the
Speaker
¶
together.
Note that once the
Metal Nut
¡
is fully tightened, it may
embed some marks on the
back of the
Satellite Speaker
¶
. However, these marks will
be covered by the
Metal Nut
¡
Step 6: Mount the
Attach-
ment Plate
¢
into a wood
stud on the wall, using four
#10 pan-head wood screws
at least one inch long (not
supplied)
•
. Make sure that
all four screws are driven
into the stud and not into
drywall.
If the bracket needs
to be mounted in drywall, the
customer is responsible for
selecting and using appro-
priate wall-anchors and
screws.
Important Note:
The
Metal
Nut
¡
must be fully tight-
ened against the
Satellite
Speaker
¶
as described in
Step 5 before beginning Step
WALL-MOUNTING
1
2
3
4
8
5
1
2
3
4
5
6
7
8
