25
24
9. Remove the protective wrapping.
instaLLinG sPikes
Project Everest speakers are shipped with round-tipped feet on
the bottom of the cabinet. If you would like to use pinpoint spikes,
remove the round-tipped feet and replace them with the supplied
pinpoint spikes. If the round-tipped feet are hard to loosen, use an
11/16-inch (18mm) wrench.
imPortant:
To prevent damage (scratches, indentations, etc.)
to wood or linoleum floors due to the weight of these speakers,
always use the included coasters. Be especially sure to use the
coasters on tile surfaces to prevent cracking the tile.
removinG the GriLLes
Project Everest loudspeakers are shipped with their grilles installed
on the enclosures. You will need to remove the grilles to access
the adjustment panels when you set up your speakers. You can
remove the grilles with the following procedures.
1. Hold the lower part of the grille with both hands and push it up.
Push bottom of grille uP
2. Pull the bottom of the grille toward you to remove the grille from
the lower pins on the enclosure.
Pull bottom of grille out
3. Pull the grille down and remove it from the enclosure.
Pull grille DoWn and remove
Repeat the above steps in reverse order in order to install the
grilles back on the enclosures.
3. Remove the cardboard and packing materials. Remember to
take the accessories out from the upper endpads.
remove
accessory
Package
4. Remove the upper endpads.
5. Together with the bottom cardboard, slide the loudspeaker
system down from the bottom board
6. Cut tapes at the corners of the bottom cardboard.
7. Slide the loudspeaker system together with bottom endpads
out toward you.
8. Lift the system slightly on the right and left, in turn, to remove
the bottom endpads.
