When deciding upon a location for the JBL Control CRV
speaker, take care NOT to install the mounting bracket closer
than 3” (7.6 cm) to the ceiling. Any closer than 3” (7.6 cm) will
not allow the clearance needed to position and slide the JBL
Control CRV speaker into the mounting bracket.
2. Attach the mounting bracket to the wall. Be sure to use
appropriate anchors.
3. Connect the stripped bare wires to the input terminals of the
JBL Control CRV speakers.
4. Set the tap selector switches to the desired 70V/100V tap.
THRU position is not advised due to parallel speakers providing
too low of an impedance for most low impedance power
amplifi ers.
5. The mounting brackets are designed to trap the fl ange of the
JBL Control CRV speaker by securing the mounting-bracket
cap with two screws through the bottom of the mounting
bracket. Run the wire through the rear cable-management
hole in the mounting bracket, and rest the JBL Control CRV
speaker’s rear fl ange in the mounting bracket, as shown. This
will support the weight of the speaker. Now slide the mounting
bracket caps over the assembly. Secure the mounting-bracket
cap by inserting two #10-32 x 2” screws (provided) through it
into the bottom piece of the mounting bracket and tightening.
6. Rest the second JBL Control CRV speaker’s rear fl ange in
the mounting bracket, as shown. Secure the mounting bracket
cap with two #10-32 x 2” (M5 51 mm) screws through the
bottom of the mounting bracket.
ceiling
3" Minimum
distance from ceiling
to top of bracket
(horizontal mounting)
Appropriate
anchors
Mounting-Bracket Cap
Mounting Bracket
#10-32 x 2" Screws (2)
(side view)
(side view)
#10-32 x 2"
Screws (2)
INSTALLATION
9
