JBL AV2, User Manual

Page: 17 / 134

JBL
®
Performance™ Series AV2 Audio/Video Processor
Basic Operation
2-7
11. POWER SWITCH
Use the Power switch to connect or disconnect power from the AC
Input connector to the AV2 processor. When the AV2 is powered on,
the front panel Standby button or remote control ON and OFF
buttons can be used to activate and deactivate Standby mode. When
the AV2 is powered off via the rear panel switch, the Standby and On
modes are not available.
12. AC INPUT CONNECTOR
Provides power to the AV2 through the supplied power cord.
13. TRIGGER OUTPUT CONNECTORS
Provide a 12V DC output to control connected components. Two
trigger output connectors are available as 3.5mm mono mini
phone jacks. The OUT 1 connector is the power trigger and is not
configurable; it is activated when the AV2 is powered on or taken
out of Standby mode, and deactivated when the AV2 is powered
off, either from the rear panel or by putting the AV2 into Standby
mode. The OUT 2 connector can be configured independently for
each input; refer to
Section 3: Setup for more information on how to
configure the OUT 2 trigger.
Note: The OUT 2 trigger is referred to as “TRIGGER 2” in the Input Setup
menu.
14. RS-232 CONNECTOR
The RS-232 serial connector provides serial remote control through a
standard RS-232 connection. Refer to the JBL Web site (www.jbl.com)
for more details on controlling the AV2 processor via the RS-232
connection.
15. PREAMPLIFIER OUTPUTS
Provide output for external power amplifiers for applications that
require them.
16. DOCK CONNECTOR
Provides an interface for iPod, which can then be accessed through
the AV2 rear panel. To use this feature, the Dock option must be
installed to the Dock connector. With a compatible iPod connected
to the AV2, selecting the Dock input allows you to play audio files
from the iPod. You can view and navigate through the iPod menus
using the AV2 remote control. For more information on the Dock
option and how to use your AV2 with iPod, refer to
Section 5: PC
and Dock Controls .
17. ZONE 2 AUDIO OUTPUT CONNECTORS
Provide preamplifier audio outputs for Zone 2.
18. STEREO ANALOG AUDIO INPUT CONNECTORS
Provide stereo analog audio input. Six stereo analog audio input
RCA connectors labeled 1 to 6 are available.
19. MICROPHONE INPUT CONNECTOR
Provides a microphone input for system calibration. The
microphone input is only for use with the supplied microphone
during the system calibration process. See
Section 3: Setup for more
information regarding system calibration and setup.