JBL AV2, User Manual

Page: 14 / 134

Basic Operation
Harman Consumer Group, Inc.
2-4
When the AV2 is in Standby, pressing a Zone 2 input selection
button powers on the AV2, selects the input in Zone 2, and turns off
the Main Zone.
7. ZONE 2 OFF BUTTON
Deactivates Zone 2. When Zone 2 is off, the Zone 2 OFF button on
the front panel lights red.
8. MAIN ZONE OFF BUTTON
Deactivates the Main Zone. When the Main Zone is off, the Main
Zone OFF button on the front panel lights red.
Note: Activating the Main Zone OFF button on the front panel turns off
the audio; however, the video continues to be output through both the
analog and HDMI video outs. If using the HDMI Video In connection, only
the HDMI video is output. If the analog Video In is used, then both analog
and HDMI video is output. Main Zone OSD (On-Screen Display) menus
are also still available.
9. MUTE BUTTON
Mutes the Main Zone and Zone 2 volumes. Press the MUTE button to
mute the Main Zone volume level; “MUTE ON” appears in the
two-line and OSD displays. Press the MUTE button again to restore the
volume to its original level. If a front panel Zone 2 input button is held
down, then pressing the MUTE button on the front panel will mute the
Zone 2 output.
On the remote control, pressing the volume button once while the
volume is muted turns off mute. Pressing and holding the Volume
button, while the sound is muted, resets to the original pre-mute
volume level and then increases or decreases the volume from that
point, turning off mute.
The LED in the MUTE button lights red when the Main Zone mute is
active, green when the Zone 2 mute is active, and amber when
both Zones are muted. The volume can also be muted by using the
MUTE button on the remote control, which functions in the same
manner. However, the remote only mutes Zone 2 if the touch
screen is in the “Zone 2” menu layer.
10. ON/STANDBY BUTTON
Toggles the AV2 between On and Standby. The rear panel Power
switch must be set to the ON position for the Standby button to be
active. When the AV2 is in the Standby mode, pressing the Standby
button turns the unit on and changes the light in the Standby
button from red to blue.
Power is still supplied to the AV2 when
Standby mode is activated.
When the rear panel Power switch is set to the ON position or AC
power is applied or restored, the AV2 automatically enters Standby
mode.
Note: When taken out of Standby, the AV2 activates the Zone inputs that
were active in the previous operating session.