Choose the needle and the suction cup that best fits the component and start working as follows:
Maximum working temp: 250ºC (482ºF)
Operation
1. Suction
Pick & Place
Ref. T260-A
2. Release
This tool helps you easily place and remove SMDs of any size thanks to the suction system.
Pick & Place
Press the button to
start/stop the suction
Once the suction is
activated, cover the
pen hole with your
finger and lift off the
component.
Insert the needle
with the appropriate
cup for a correct
suction process.
Lift your finger
to release the
component in the
appropriate place.
You should
avoid the needle
protruding from the
lower part.
Pick & Place
Ref. T260-A
Straight
Needles Set
Ref. 0901546
Bent Needles Set
Ref. 0861660
1.
Pull off the fuse holder and remove the
fuse. If necessary use a tool to lever it off.
2.
Press the new fuse into the fuse holder
and replace it in the station.
Fuse holder
Fuse holder
Fuse
12
13
Suction Cups
Ref. 0930110
Maintenance
- Clean the station screen with a glass
cleaner or a damp cloth.
- Use a damp cloth to clean the casing and
the tool. Alcohol can only be used to clean
the metal parts.
- Maintain heating element clean prior to
storage in order to avoid its oxidation.
Rusty and dirty surfaces reduce heat
transfer.
- Periodically check all cables and tubes.
- Replace a blown fuse as follows:
- Replace any defective or damaged pieces. Use original JBC spare parts only.
- Repairs should only be performed by a JBC authorized technical service.
Before carrying out maintenance or storage, always allow the equipment to cool.
Clean periodically
12
www.jbctools.com
13
