ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
6/47
SUPER QUADRA BEAM
SL I: the device will run 100% sinchronously with the master device.
SL 2: the device will run sinchronously with the master device, but from time to time the effects will be
inverted to create more diversity in the show.
Once the right mode is selected, press the ENTER button to confirm.
Press the
MENU
button for about 2 seconds to store the setting and to return to running mode.
Sound Mode
Used to activate or to deactivate the sound mode to trigger the shows.
Press the MENU button until
is shown on the display.
Press the ENTER button to select.
Use DOWN and UP button to select one of the available modes:
(sound mode ON)
the shows are triggered by the internal microphone.
(sound mode OFF)
the shows runs at slow speed.
Once the right mode is selected, press the ENTER button to confirm.
Press the
MENU
button for about 2 seconds to store the setting and to return to running mode.
Blackout Mode
Blackout mode: when no DMX-signal is detected, the unit goes in blackout.
No blackout mode: when no DMX-signal is detected, the unit automatically switches to master mode.
ALWAYS set to “No Blackout” when the unit is used in standalone or master (master/slave) mode!!!
Press the MENU button until
is shown on the display.
Press the ENTER button.
Use DOWN and UP button to select
(blackout) or
(no blackout).
Once the mode is selected, press the ENTER button to confirm.
Press the
MENU
button for about 2 seconds to store the setting and to return to running mode.
Led Display
Display on: display is always on.
Display off: display is off when not used.
Press the MENU button until the display shows
.
Press the ENTER button.
Use DOWN and UP buttons to select
(display always on) or
(display off when not used).
Once the mode is selected, press the ENTER button to confirm.
Press the
MENU
button for about 2 seconds to store the setting and to return to running mode.
Display Inversion
Display inversion: display is readable when the unit is mounted upside down.
Press the MENU button until the display shows
Press the ENTER button, the display starts blinking.
Use DOWN and UP buttons to select the display inversion or the normal display.
Once the mode is selected, press the ENTER button to confirm.
Press the
MENU
button for about 2 seconds to store the setting and to return to running mode.
Self-Test
Used to activate the internal “self-test” program that runs continuously.
Press the MENU button until the display shows
.
Press the ENTER button to start the internal self-test program.
The unit will run continuously in sequence each individual LED
This self-test allow the user to check if all the LEDs are working perfectly.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
