ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
4/38
LED CLUBSCAN
The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
CONTROLLING UNIT
1. Standalone 1unit:
Just connect the unit to the mains and put on some music. The unit will start working automatically to the
rhythm of the music.
2. Two or more units in master/slave setup:
Connect 2 or more units together using good quality balanced XLR microphone cables . The unit that
has no cable connected to its input will react as master; the others are the slave units.
Don’t forget to set the DMX addresses as follows:
Master unit:
DMX start address MUST be set to 001. (first DIP switch = ON, all other are OFF)
Slave units:
DMX start address may have any value but NOT 001 (example: set the first 3 DIP
switches to ON)
It is possible to inverse the behavior of a slave unit by changing the position of DIP-switch n°10. Just try
it and see if the effect becomes better. Changing DIP-switch n°10 on the master has no effect.
3. Connect the optional CA-8 or RF-8 controller for more control:
The CA-8 or RF-8 controller can only be used in standalone or master/slave mode:
CA-8 wired remote:
Connect the controller to the jack input of the first unit (master).
RF-8SET wireless remote:
the wireless remote has two parts:
RF-8T:
small RF-transmitter that can control up to 5 effects.
RF-8R:
small RF-receiver that should be connected to the DIN 5pin input of the LED
CLUBSCAN. See the installation manual of the receiver for more information.
Now you can control all the connected units:
STANDBY BUTTON:
Press this button to start/stop blackout mode on all connected units.
MODE/FUNCTION BUTTONS:
With the MODE button you can select 3 different modes:
The LED is off:
with the FUNCTION button you can select 3 different strobe
functions.
The LED is on:
with the FUNCTION button you can select different shows.
The LED is blinking:
With the FUNCTION button you can select the desired
gobo/color.
