ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
7/10
CAM-LITE 200
Note: The firmware of this unit can be upgraded using the [Firmware Updater] (order code : B04319) from
Briteq with Windows
®
software.
[Special Function > Factory Setting]
Used to reset the functions of the projector to the factory settings.
•
Press the [MENU] button to access the different functions in the menu.
•
Press the ▲/▼ buttons until the desired function is showing on the display.
•
Press the [ENTER] button: the display shows [Special Function>Factory Setting].
•
Press the [ENTER] button again to select [No] or [Yes].
[Special Function > Password]
Used to put a password in the projector.
•
Press the [MENU] button to access the different functions in the menu.
•
Press the ▲/▼ buttons until the desired function is showing on the display.
•
Press the [ENTER] button: the display shows [Special Function>Password]
•
Press the [ENTER] button to set a password (from 000 to 999).
OVERHEAD RIGGING
•
Important:
The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
•
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
•
Locate the fixture in a well ventilated spot, far away from any flammable materials and/or
liquids. The fixture must be fixed
at least 50cm
from surrounding walls.
•
The device should be installed out of reach of people and outside areas where persons
may walk by or be seated.
•
Before rigging make sure that the installation area can hold a minimum point load of
10times the device’s weight.
•
Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop more
than 20cm if the main attachment fails.
•
The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
•
Don’t cover any ventilation openings as this may result in overheating.
•
The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
ELECTRICAL INSTALLATION
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
ELECTRICAL INSTALLATION FOR TWO OR MORE UNITS IN DMX-MODE:
Use this function when you want to control the projectors by any DMX controller.
•
Connect the projectors as shown in the drawing below.
•
First put the projectors in the desired DMX-mode: see the different DMX-charts and choose the one that
suits you best.
