JB-Lighting P9 Beamspot, Operating Instructions Manual

Page: 9 / 44

- 09 -
P9
Never connect this device to a dimmer pack.
During first use, some smoke and odour may occur. This is normal and does not necessarily
mean that the device is defective.
The device becomes hot during operation. Never touch the device with bare hands during
operation!
When replacing fuses, only use the same types with identical values! Only have fuse replacement
carried out by a qualified technician
If the device has been exposed to strong temperature fluctuations (e.g. after transport), the device
must not be switched on immediately. The resulting condensation can damage your device.
Leave the device switched off until it has reached room temperature.
If the P9 Beamspot is operated below 0°, gobo/prism swapping and gobo/prism rotation
are reduced in speed. This is a protective mechanism of the P9 Beamspot, as at low
temperatures the lubricant is relatively viscous in the rotational mechanism and can
therefore cause the effect to be slurred. From indoor temperatures of 1° and upwards, the
spotlight runs normally! This temperature is quickly reached under normal operation (LED
engine on).
Do not shake or knock the device. Avoid brute force during installation or operation.
This light was designed for indoor use only. Do not expose this device to rain or moisture.
When choosing a mounting location, make sure that the device is not exposed to extreme heat,
moisture or dust.
Ventilation openings and slots in the head and foot of the spotlight are used for ventilation
to ensure reliable operation of the device and to protect it from overheating, these openings must
not be covered.
Never cover the front lens when the spotlight is in use.
The openings should never be covered with substances or other objects so that the airways are
blocked.
This device must not be operated in an environment without adequate ventilation.
The device may only be operated when the housing is closed and all screws/Camlocs are firmly
tightened.
The device must always be secured with an additional safety device.
Ensure that the area below the spotlight is clear during installation, alteration and removal.
ATTENTION: This fixture corresponds to protection class I. For this reason, this
spotlight must be connected to a mains socket with earthing contact. !
ATTENTION: DAMAGE TO EYES! Do not look into the light source for long periods
during operation. This can be harmful to the eyes. Attention: potentially hazardous
radiation - Risk group 2 based on DIN EN 62471