4.2 DEFAULTS - Set to factory default
4.3 DMX ADDRESS - DMX addressing
Change the DMX address directly by means of the keys "UP" and "DOWN". Confirm and
store it by pressing key "ENTER". The DMX address can also be changed in the menu
.
DMX ADDRESS
To set back the JBLED A7 to factory setting choose menu point
After confirming
in the display, the personal settings of the
JBLED A7 will be set back to factory default.
If the white balance was adjusted before, it will be not affected by the set back to factory
default.
FACTORY DEFAULT,
LOAD DEFAULTS.
SURE ?
25
4.4 PERSONALITY
DMX MODE
The JBLED A7 offers 4 different operating modes (see DMX protocol page 25). For using
the full range of DMX channels use the Standard 8 BIT or Standard 16 BIT modes.
Switching 8 BIT to 16 BIT allows 16 BIT access to the RGB channels
In order to operate the JBLED A7 with less DMX-channels the DMXMode can be set to
. In this mode the channels colour macro, colour wheel, pan/tilt
speed, effect speed and blackout move are deactivated. That means the colours can be
operated by the RGB channels only. (See page 25 DMX protocol).
COMPRESSED MODE
CAMERA MODE
For flicker free recording in TV-studios the JBLED A7 zoom offers three different modes
from 50 Hertz (PAL, Secam) to 60 Hertz (NTSC). Flex mode is designed, if cameras have
a refresh frequency that makes the 50 or 60Hz settings ineffective. Access the menu
and choose the required frequency. To confirm press
“ENTER”. This can be also controlled with the control channel (channel 5) via lighting desk.
PERSONALITY, CAMERA MODE
PAN/TILT
sets pan and tilt to 8 bit or 16 bit control resolution. The default setting is
16 bit. If this fine resolution is not required, you can set to 8 bit for quicker scrolling through
pan/tilt values. The
and
commands invert the direction of pan
and tilt.
command sets pan commands to tilt and vice versa.
RESOLUTION
PAN INVERS
TILT INVERS
The PAN/TILT SWAP
CURVES
Dimming curves can be adjusted for the dimmer channel and the RGB channel. There is a
square-law curve for finer control at low intensity and coarser control at high intensity and
a linear-law curve available.
SHORTEST DISTANCE
This setting is only for the colour wheel channel. On
(default) it always take the
shortest route from one colour to another. On
it routes only from white to cyan and
backwards.
ON
OFF
DMX INPUT MODE
The JBLED A7 provides an embedded radio-DMX receiver. The receiver works together
with the JB-lighting Wireless TRX transmitter. To enable the JBLED A7 to receive radio-
DMX change the menu from
(factory default) to
. The fixture
needs to be logged-in to the Wireless TRX transmitter. To log-in press the „Start“ button
(see also manual Wireless TRX). The radio channel is displayed when the JBLED A7 is
logged. The main display will show the intensity of the incoming signal. If the JBLED A7
is connected both via DMX cable and radio-DMX, the cable signal has priority.
WIRED
WIRED/WIRELESS
