- 9 -
NOTE
–
Later model openers
may have
‘
S
’
in place of
‘
SET
’
,
‘
C
’
in place of
‘
CODE
’
,
‘
+
’
in
Place of
‘
UP
’
and
‘
-
‘
in place of
‘
DOWN
’
4
.
Photo beam setting
1. Auto-close setting
Press and hold
“SET” button
for 3 seconds until the LED
flashes
“1”. Press “UP”
or
“DOWN” to increase or
decrease, adjust the LED to flash
”4”, then press “SET”
button to enter into auto-close setting, the LED displays
the current setting.
Press “UP” or “DOWN” button to adjust the auto
-close
time. Press “UP” button once, the auto
-close time will
increase 1 minute, the maximum time is 9 minutes.
Press “DOWN” button once, the auto
-close time
decreases by 1 minute. The auto-close function will be
turned off wh
en the LED displays “0”.
Press “SET”
button to confirm, the opener returns to standby mode.
The auto-close function is only be available when the
door is fully open and the photo beam function is on.
The default setting is “o”
Press and hold
“
SET
”
button for 3 seconds until the
LED flashes
“1”
. Press
“
UP
”
button until the
LED flashes
“
3
”
, press
“
SET
”
button. The display is now
in photo beam setting mode. The LED displays the
current setting.
Press
“
UP
”
button, the LED displays
“
1
”
, the Photo
beam Function is enabled. Press
“
DOWN
”
button, the
LED displays
“
0
”
to cancel this function. Press
“
SET
”
button to confirm. The opener returns to standby mode.
The default setting of photo beam is
“
0
”
.
Notice: Default setting must be used when no photo
beams are installed.