Jayco PINNACLE FIFTH WHEELS 2019, Owner'S Manual

Page: 121 / 185

119
Section 8: Plumbing System
"SANITIZE” (or Siphon Fill) the Fresh Water Tank via Pump
1. Connect a garden hose to the city water inlet (do not use your fresh water hose to sani-
tize the water lines or the tank).
2. Set the colored coded valves to the SANITIZE setting:

(A) White handle pointing down

(B) Blue handle pointing down

(C) Black handle pointing right

(D) Red handle pointing left

(E) Green handle pointing right

The water heater is automatically bypassed on this setting.
3. Place the other end of the hose in a container holding sanitizing solution.
4. Turn the pump switch ON.
5. Fresh water tank should begin drawing solution out of the container. To aid siphoning
place the container on a surface approximately (2) feet off the ground.
6. Pump until solution is drawn out of the container, or tank is at the desired level.
7. Turn the pump Switch OFF.
8.
Disconnect the garden hose from the city water fill inlet on the utility center.
“DRY CAMPING” (pump supplies water from the fresh water tank)
1. Make sure the fresh water tank has an adequate supply of water.
2. Set the color coded valves to the DRY CAMPING setting:

(A) White handle pointing right

(B) Blue handle pointing down

(C) Black handle pointing down

(D) Red handle pointing up

(E) Green handle pointing up
3. Turn the pump switch ON.
4.
Water should be available to all fixtures.
5. Turn pump OFF when water is not being used.
NOTE: Refer to the Sanitizing Plumbing System section before
starting this process.
NOTE: To fill the fresh water tank without a pressurized water
source, refer to SANITIZE (Siphon Fill) section, and use a container
holding fresh potable water and a hose. Water will be drawn into
the tank by the pump. There is no gravity fill inlet on the recreation
vehicle. DO NOT OVERFILL THE TANK!
Table of Contents Maintenance Record