Jayco NORTH POINT 2023, Owner'S Manual

Page: 81 / 181

75
Section 6: Electrical System
Heating/Cooling operation
There are no thermostats located in the RV. Heating and cooling is controlled through the
BMPRO RVMaster touchscreen Climate screen. One or more small sensors are located on
the walls of the RV. These sensors work with the touchscreen to monitor the temperature in
an area of the RV and adjust according to climate settings on the touchscreen.
Home Screen
Shows an overview of the key features of your RV: climate, lights, motors, tanks and energy.
Water Screen
Shows tank monitors (black, gray, fresh) water pump switch, water heater switches for gas
and electric and possibly the tank heater switch.
Motors Screen

Shows controls for the leveling system, awnings, slideouts, jacks and the ramp
door (if applicable).

The app on your smart device automatically locks out the Motors screen on your
device. You must swipe to unlock the screen in order to operate motors.

Only one motor may be operated at a time.

When a motor is in operation, motor control is disabled on any other device run-
ning the RVMaster app.
Climate Screen
Shows the thermostat to control heating and cooling in the RV, and fan speed.
Lights Screen
Turn lights on and off along with ability to dim certain lighting with sliders.
Energy Center Screen
Shows generator on and off, AGS (auto generator start), battery levels, and fuel levels.
Fans and Vents Screen
Shows kitchen and bath fans and automatic vents (if equipped). Turn fans on and off, and
open and close automatic vents.
General Settings Screen
(gear icon at top right corner)

Check the Bluetooth connection between RVMaster Controller (touchscreen) and
the RVMaster Node.

Set preferred temperature units (Fahrenheit/Celsius).

Access the AGS Energy settings.

Check the battery condition of any installed remote control (RVMaster Switch).

Access a digital version of the RVMaster owner manual.
 TPMS sensors – DO NOT MOVE WITH THE TIRES!

The TPMS sensor on the front tire (on either side of the trailer)
STAYS
at
the front tire position when rotating tires.

The TPMS sensor on the middle tire (on either side of a 3 axle trailer)
STAYS
at the middle tire position when rotating tires.

The TPMS sensor on the rear tire (on either side of the trailer)
STAYS
at the rear tire position when rotating tires (on both dual and triple axle
trailers).

This guarantees tire pressures displayed on the touchscreen are accurate-
ly showing the correct tire locations on the trailer.
Table of Contents