Jayco NORTH POINT 2023 Owner'S Manual Download Page 100

Page: 100 / 181

Section 7: Fuel & Propane System

The propane piping system is designed for use with

propane only. Do not connect natural gas to this system.

This label should be kept permanently affixed to your RV.

Refer to your Warranty Packet for more information on the LP
gas system components.

Maintenance

Propane gas is normally non-corrosive - you need not worry
about the inside of your container. However, the outside should
be kept free from rust by a periodic coat of paint in a light re-

flective color. Rust, scratches and/or dents can affect the safety

of the cylinder. Inspect the cylinder at regular intervals.

Ifs a problem, have it evaluated by a qualified technician and

discard it. DOT requires that a visual inspection be made prior

to each filling.
Any cylinder that has been exposed to fire, leaks or seems dam

aged should not be refilled.

Do not attempt to repair any containers, container valves, regu-

lator or appliances by yourself. Use only trained certified pro

pane gas service technicians to perform repairs.

Propane Cylinder Recertification

DOT cylinders may only be used for 12 years after their manufacture date (the number of

years for certification may vary in your area). After that, the cylinders must be “recertified”

which provides another five years of use.
The cylinders can be recertified every five years thereafter. Federal DOT (Department of

Transportation) regulations require periodic inspections and re-qualifications of the propane

cylinders. DO NOT USE damaged or rusted containers.

Verify with your local propane dealer that all required inspections and certifications have

been completed on the propane cylinder within the correct time period before refilling the

cylinder. Have the LP system checked for leakage each time a cylinder is refilled or after

any part of the propane system has been disconnected.

Hoses, Pipes, Tubes and Fittings

The hoses, pipes, tubes and fittings used in your propane system are designed to withstand

pressures exceeding those of the propane system. However, because environment and time
can both contribute to the deterioration of these components, they must be inspected for
wear at regular intervals.

Be sure to inspect the hose before each season and when having the tank refilled. Look for

signs of deterioration such as cracks or loss of flexibility. When replacing the hose or other

propane components, make sure to always replace them with components of the same type
and rating (check with your dealer).

Fittings are used to connect the various system components to each other. The P.O.L. fitting

at the end of the propane supply hose is made of brass so that pipe sealants are not necessary
to prevent leaking.

It also has a left-handed thread, which means that it is turned clockwise to remove, and

counter-clockwise to tighten. The P.O.L. fitting has been designed to help restrict the flow

of LP gas in the event of a regulator failure or hose malfunction.

“Do not fill to more

than 80%” Label

(label appearance may

not be exact)