Jayco JAY SPORT 2018, Owner'S Manual, Page: 64 / 145

Section 4: Vehicle Operation
56
Step 10b - (Slide out-if so
equipped)
The window bow brace for
the slideout is typically stored
under the dinette table. Attach
the “claw” to the curved
window bow (3-A) between
the screws. Attach the loop end to the bracket near the ceiling. Put the tab end of the brace
in the wide hole of the bracket (1) and slide toward the narrow end (2).
Step 11 - Flip the bed flap over the edge of
both beds (
arrow
). Bed flap is underneath the
mattress on both beds.
Step 12 -
Front bed – pull the outside tent flap
underneath the bed and attach to the Velcro
under the bed. Repeat for the rear bed.
Step 13 -
If equipped with a slideout, Velcro
the tent sides to the slideout. Adjust for water
run-off.
Step 14 – Lifter post safety support
installation
Install the metal safety supports over the (2)
lifter posts at
opposite corners
of the camping
trailer. Wrap and Velcro the lifter post covers in place. Angled end of the support channel
goes to the top of the lifter post. The notched sides go at the bottom and snap on to the lifter
posts. No tools are necessary to install these supports.
Table of Contents Maintenance Record