TO REMOVE REFRIGERATOR HANDLE:(FIG. 5-9)
(Handles may be easier to reverse while the doors are
off.)
1. Remove the two screws attaching the handle to
the top of the refrigerator door.
2. Swing the top of the handle away from the door
and slide the handle down and off of the dovetail
button.
3. Remove the screw and dovetail button and install
them on the other side, moving the hole plugs
from the corresponding holes to the opposite
side.
TO ATTACH REFRIGERATOR HANDLE:
1. Start with the handle offset away from the door.
Place the bottom of the handle over the dovetail
button, swing the handle into an upright position
and pull upward, locking into place.
2. Secure the top of the handle with the screws.
To attach trim:
1. Slide both trim locks out of trim.
2. Insert the new adhesive trim locks contained in
the literature pack.
NOTE: The trim lockmust be removed and installed by sliding over the two donut shaped
areas.
3. Install the trim to the handle by sliding it over the base of the handle. Carefully align the trim
and press down at the trim locklocations.
4. Replace the hole plug on the opposite side. Use rubbing alcohol to remove any adhesive
residue from the old trim locklocations.
TEMPERATURE CONTROLS
Cool Down Period
To ensure safe food storage, allow the refrigerator to operate with the
doors closed for at least 8 to 12 hours before loading it with food.
Refrigerator & Freezer Controls
NOTE: When first setting the controls or when changing a setting,
wait 24 hours for the temperature to stabilize before
making additional changes.
Temperature Adjustment
NOTE: When first turning the refrigerator on,
move the refrigerator and freezer controls
to
t
which is the recommended initial
setting. After 24 hours, adjust the controls
as needed.
Appliances
57
Dovetail
Button
Screw
Full
Length
Trim
Adhesive
Trim Lock
Trim
Lock
Lock Handle
over
Dovetail
Button
Screw
Handle
Fig. 5-9
1
2
3
4
5
6
7
Warm
Cold
Allow 24 hrs for
adjustments
Recommended
Setting
Warmer
Colder
Fig. 5-10
1
1
2
2
3
3
4
4
5
6
7
Warm
Warm
Cold
Cold
Allow 24 hrs for
adjustments
Fig. 5-11