61
MANUAL MODE OPERATION
When you select one of the manual modes of operation, the light bar beside the AUTO
goes out in the center display and only the light bar beside either AC, LP, or DC remains.
AC means that the refrigerator is operating on AC electric. LP means that the refrigerator
is operating on LP gas. If the energy source is interrupted, the refrigerator stops
operation. Refer to the “Fault Codes” in the manufacturer’s owner’s manual.
IGNITION OF LP GAS IN EITHER AUTO OR MANUAL MODE
Note: On initial startup of the refrigerator, ignition of the LP gas may not occur within 30
seconds.
If ignition of the LP gas does not occur with 30 seconds, the gas safety valve of the
refrigerator closes, and the refrigerator stops operation. Refer to the “Fault Codes” in the
manufacturer’s owner’s manual. The fault code remains until you push the ON/OFF
button two times (to stop and start the refrigerator). If ignition does not occur after two
or three times, check the LP gas supply line; consult your local dealer or an authorized
Norcold Serivice Center; change to manual mode and operate on AC electric.
Operating the Refrigerator Controls – N841
CONTROL PANEL
Fig. 5-12
The refrigerator control panel is between the freezer compartment and the fresh food
compartment. To maintain the operating control functions of the refrigerator, a 12 volt
DC power supply is necessary. The refrigerator and any other DC components in the
vehicle receive DC power from the 12 volt system of the vehicle; either an auxillary
battery, a converter, or the vehicle engine battery.
The ON/OFF button (1) starts and shuts down the refrigerator. If the refrigerator is shut
down, press the ON/OFF button to start the refrigerator in auto mode. If the refrigerator
is operating, press and hold the ON/OFF button for two seconds to shut down the
refrigerator.
The TEMP SET button (3) controls the temperature adjustment of the freezer and the
fresh food compartment. The temperature adjustment that you select does not change if
the operation mode of the refrigerator changes. Press the TEMP SET button and the
temperature setting “1-9” appears in the center display (4). Push and hold the TEMP
SET button and the temperature setting changes. The number “9” is the coldest tempera-
ture setting.
The MODE button (2) controls the operation mode of the refigerator. Push and hold the
MODE button and each of the four operating modes of the refrigerator flash one at a time
Summary of Contents for Conventional Travel Trailer
