Jayco Conventional Travel Trailer, Owner'S Manual

Page: 29 / 95

20
Operation (Manual Slideout – Qwest Travel Trailer)
EXTENDING ROOM
1. Release the travel lock behind the center door of the overhead cabinets located above
the sofa.
2. Release second travel lock located below the sofa.
3. For one-person operation, push slideout into the extended position by pushing on
sofa. For two-person operation, push each side of slideout until the slideout locks in
place. Loud clicking of the slideout at this point is normal.
RETRACTING ROOM
1. Lift sofa skirt.
2. Push up on release handles and pull slideout to the retracted position.
3. Lock bottom travel lock.
4. Lock top travel lock.
Maintenance
See “Slideout” section under Maintenance in Chapter 7.
Troubleshooting Electric Slideout
If the slideout does not move when the slideout switch is depressed, follow these steps.
1. Make sure the ON/OFF switch is in the correct position.
2. Check the battery for full charge and good wire connections.
3. Check for loose connections on the slideout controller located behind kitchen
drawers.
If slideout still will not operate, follow these steps.
1. If the slideout is extended, see the section on overriding the electric slideout system.
2. If the slideout is retracted, leave it in that position and install the “travel bars.”
3. Take the trailer to the nearest dealer or service center.
If the slideout extends crooked, or only one side moves, follow these steps.
1. Follow steps 1-4 in the section on overriding the slideout system to disconnect the
motor.
2. Retract slideout using the hand crank. You may need to push the side that is not
sliding to get it to retract all the way.
3. Once the slideout is fully retracted, install the “travel bars.”
4. Take your travel trailer to nearest dealer or service center.