Jayco 2004 Jay Flight, Owner'S Manual

Page: 15 / 104

IF A LEAK IS DETECTED:
• Turn off all appliances which utilize LP gas.
• Make sure that everyone is out of the RV, including pets.
• Turn off the LP gas at the tank(s).
• Take your RV to your independent, authorized dealer and have the system repaired
before using it again.
I
WARNING: WE STRONGLY RECOMMEND THAT YOU HAVE A
PROFESSIONAL TEST YOUR LP GAS SYSTEM FOR LEAKS ONE
TIME EACH YEAR AS PART OF NORMAL MAINTENANCE.
Electrical System Safety
Circuit breakers and fuses are installed to protect electrical circuits from overloading. Do
not make unauthorized changes to circuitry or add fixed appliances. If you wish to make
changes, consult your independent, authorized dealer and they will assist you in obtaining a
safe installation.
An approved power cord has been supplied with the vehicle. Always use this cord for
hook-up to 120-volt shoreline power. The cord has a three pin plug, which provides proper
grounding through the third (round) pin. Grounding is personal protection from electrical
shock.
I
WARNING: Do not use an adapter, cheater, or extension cord that will
break the continuity of the grounding circuit connected to the third pin.
NEVER remove the grounding pin to connect a non-grounded, two-prong
receptacle. Any deviation from this will potentially cause a fire from
overheating.
Fire Extinguisher
A fire extinguisher is installed in each vehicle and is located near the entrance door in the
trailer. Be familiar with its location and operating instructions as printed on the
extinguisher and any materials from the extinguisher supplier or manufacturer. It is too late
to become familiar with an extinguisher when an emergency is at hand.
The fire extinguisher is a dry chemical, nonrefillable extinguisher. Do not test this
extinguisher by partially discharging. Doing so will cause loss of pressure making the
extinguisher unusable. The extinguisher must be discarded and replaced by a new one if
any use has occurred.
INSPECTION AND MAINTENANCE
To insure that your fire extinguisher will be ready when needed:
• Read and follow all instructions on label and in owner’s manual.
• Inspect the extinguisher AT LEAST once a month - more frequently if exposed to
weather or possible tampering.
• Check pressure by pressing in white indicator button. If button does not spring back,
extinguisher will not work properly and must be discarded.
• Be sure the yellow lock pin is firmly in place.
5
Safety