Jaycar QV-3798, Instruction Manual

Page: 11 / 12

b. Video Frame and Watermark
Show the image ahead of the car where the car current is. Watermark shows the
time, 3-axis G-sensor value, driving orientation (D), actual coordinate and driving
speed.
* D value indicates the direction that your car heading, 0 for North, 90 for East, 180
for South and 270 for West.
c. Driving Speed and Orientation
Display the speed value and orientation.
d. 3-axis G-sensor Curve
Show the curve of each axis: x indicates left-right, y indicates up-down, z indicates
front-back.
3. Setup
Right side to the Control Bar is a gear-shape button; press it to open the setup window.
Speed Unit: KM/H or MPH
Key trigger record time: define the record time triggered by pressing recording button.
Event trigger recording time: define the record time triggered by event (G-sensor).
On screen display: set watermark on or off in the video image.
G-sensor sensitivity: set the sensitivity for event triggering.
Overwrite: set the record overwriting on or off.
Caution: if set overwrite off. Once the card is full written, the unit will stop recording.
When you finish all setting and click ok to save it, a “setup.ini” configuration file will be
saved in your PC hard disk under the player installation directory. Copy this file in your SD card
boot directory before inserting to the card slot of the car event recorder, then when the unit is
powered on, the configuration file will be written in the flash memory automatically.
Note: Pre-trigger recording time is fixed as 10 seconds.