-11-
9. Re-power On & Reset Tracker
Send SMS “RESET*123456” to tracker, “RESET” is a command, “123456” is password. The tracker will
send back information “Reset Tracker and cancel all alarm setting”, if the password is not right, the operation is
fault, the tracker will send back information “Wrong Password”.
The tracker will power off and then power on automatically, this will take a few minutes, and then cancel all
the alarm setting in the tracker, including shock alarm, move alarm, geo-fence alarm, over speed alarm, etc.
10. Back to factory configuration
Send SMS “FACTORY*123456” to tracker, “FACTORY” is the fixed command, “123456” is password. The
tracker will send back information “Set factory setting OK”, if the password is not right, the operation is fault,
the tracker will send back information “Wrong Password”.
After this, The tracker will cancel all the alarm setting in the tracker, including shock alarm, move alarm,
geo-fence alarm, over speed alarm, delete all the authorized phone number, delete the APN and GPRS user
name and password, change the tracker password to 123456, reset the IP address, reset the system working
mode and the interval time, and so on.
11. SMS Start/Stop (Enable / Disable) Uploading Location to Server
The uploading location to internet server can be enabled (Start) or disabled (Stop) by SMS, if the
uploading location to server is disabled, the tracker will not upload location to server unless user enable (Start)
the uploading location to server function again, at this condition it still can be used as a personal tracker
without platform.
Send SMS “START*123456” or “STOP*123456” to tracker, “START” or “STOP” is a command, “123456” is
password. The tracker will send back information “Set upload start OK” or “Set upload stop OK”, if the
password is not right, the operation is fault, the tracker will send back information “Wrong Password”. After stop
uploading location to server, the tracker is just like a personal tracker.
Note: the default setting is: the uploading location to server function is enabled.
12. Enable And Disable Shock Alarm
Send
SMS
“SHOCKALARMON*123456”
or
“SHOCKALARMOFF*123456”
to
the
tracker,
“SHOCKALARMON” or “SHOCKALARMOFF” is a command, “123456” is password, the tracker will send back
the information “Set Shock Alarm On” or “Set Shock Alarm Off” to indicate the operation is success, if the
password is not right, the operation is fault, the tracker will send back information “Wrong Password”.
After enable shock alarm, the system will check shock sensor, if the shock sensor is trigger, the tracker will
send alarm and location information by SMS to the preset phone, and also send the alarm information to the
