AAA-055-00138
Rev. 1/14/15
Jaylor Owner Manual
- 39 -
Mini Mixer Models
16.2 Transporting A50 and A100 Truck Mounted Models
A50 and A100 truck mounted models
are designed to be mounted easily on a flatbed truck for
transportation.
Think SAFETY! Work SAFELY!
1. Be sure all bystanders are clear of the machine and that there are no riders on the machine.
2. Lift the mixer onto the truck’s flat-bed using a forklift with sufficient capacity for the job. Open
the forks so that they are just inside the wood skids to maintain stability when lifting. For an
A50 model, run the forks in from the door side of the under frame (see
). For an
A100 model, run the forks in from the non-power supply platform side of the under frame (see
). The mixer door should be placed near the driver side edge of the flatbed to
insure that the feed will discharge onto the ground beside the truck.
NOTE - The loaded mixer can weigh up to 2500 lbs (1134 kg) for an A50 model and 5,000
lbs (2,268 kg) for and A100 model. Be sure that the truck has sufficient capacity to carry
this load on the bed safely with the load off center.
3. Secure the four (4) tie-down brackets (see
) to the truck frame or bed using a tie-
down chain or strap with sufficient capacity for the job.
4. Be sure that the control pendant and cable is secured.
5. Never transport faster than the road or terrain conditions will allow you to do safely.
Figure 32 - Truck Mounted Model Tie-Down Bracket Locations
1. A50 Truck Mounted Mixer
2. A100 Truck Mounted Mixer
3. Tie-Down Brackets
– Secure tightly ALL four (4) brackets to the truck frame or
bed. Brackets are found at each corner of the mixer under frame.
