AAA-055-00138
Rev. 1/14/15
Jaylor Owner Manual
- 29 -
Mini Mixer Models
10.8 A100 Trailer Mixer Components
Figure 25 - A100 Trailer Mixer Components
1. Mixer Drum
– Used to contain the
feed while it is cut and mixed by the
vertical augers.
2. Vertical Augers
– Used to mix the
feed within the mixer drum and to
discharge the feed through the
unloading door.
3. Auger Knives
– Used to cut the feed
material as the augers rotate.
4. Battery
– Provides power to the
electric engine starter, electronic scale
system, hydraulic oil cooler electric
fan, hydraulic valve solenoids, and
auxiliary components (if applicable).
5. Control Pendant
– Controls door
opening and auger on/off.
6. Hydraulic Oil Reservoir/Cap
–
Remove this cap to add oil. Glass
level sight on the side of the reservoir
indicates proper oil level range.
7. Electronic Scale Indicator –
Displays
the weight inside the drum.
8. Unloading Door
– Door can be opened to
allow feed to be discharged.
9. Adjustable Clevis Trailer Coupler
– Will
couple to a standard Class I or Class II
drawbar (standard 2 inch trailer ball hitch is
also included).
10. Trailer Jack
– Raises and lowers the height
of the trailer tongue and coupler.
11. Fuel Tank/Cap
– Remove this cap to add
fuel.
12. Engine Start Key
13. Engine Oil Dipstick
14. Engine Choke
15. Engine Throttle Control
– To increase
engine speed, push throttle lever upward; to
decrease engine speed, push throttle lever
downward.
16. Hydraulic Oil Cooler Electric Fan Override
– Normally, fan is activated by internal
temperature switch. However, while the
override button is pressed in the fan will run
(with engine on). Test daily before feeding to
make sure cooler fan is functioning.
