JAY
•
LOR
®
Operator’s Manual
- 21 -
Trailer Units - Model 3650
C. After operating for 5 hours and 10 hours:
•
Retorque all wheel nuts, fasteners, and hardware.
•
Check that auger turns freely.
•
Check the auger. Remove all string, twine, or other entangled material.
•
Proceed with normal servicing and maintenance schedule as defined in the
Maintenance Section.
EQUIPMENT MATCHING
The machine is designed to be used with Agricultural tractors. To ensure a good
performance, the following list of specifications must be met:
1. Horsepower:
The minimum horsepower
that is required for a
JAY
•
LOR
®
Model 3650
Cutter-Mixer-Feeder is
90HP.
2. Drawbar
Dimensions:
The tractor drawbar
dimension must be
14
inches
between the end of
the shaft and drawbar pin
hole center for 540 RPM
units.
3. PTO
Shaft:
The tractor PTO Shaft must
meet the following specification:
540 RPM – 6-spline, 1-3/8” diameter.
Important: It is not recommended that shaft adaptors be used on the tractor shaft to
prevent operating at the wrong RPM.
4. Hydraulic
System:
For front door discharge units, the tractor must be equipped with a minimum of 2 remote
hydraulic outlets with
5 GPM (19 L/min) at 2000 psi (13,750 kPa)
. One circuit is used to
power the unloading conveyor; the other circuit is used to supply hydraulic power to the
door.
For center side door units, the tractor must be equipped with a minimum of 1 remote
hydraulic outlets with
5 GPM (19 L/min) at 2000 psi (13,750 kPa)
. This circuit is
required to supply hydraulic power to the discharge door.
DRAWBAR
TRACTOR
PTO
Figure 3 - Drawbar Setting.
