JAY
•
LOR
®
Operator’s Manual
- 3 -
Trailer Units - Model 3650
INTRODUCTION
Congratulations on your choice of a JAY
•
LOR
®
Cutter-Mixer-Feeder to complement your
operation. This equipment has been designed and manufactured to meet the needs of the
discriminating buyer for efficient cutting, mixing and feeding.
Safe, efficient and trouble free operation of your mixer requires that you and anyone else
who will be operating or maintaining the machine, read and understand the Safety,
Operation, Maintenance and Troubleshooting information contained within the Operator's
Manual.
This manual covers the Model 3650 Trailer manufactured by JAY
•
LOR
®
. Keep this manual
readily available for reference and be sure to pass it on to new Operators or Owners.
Contact your nearest JAY
•
LOR
®
Dealer or Distributor if you need assistance or information.
OPERATOR ORIENTATION
- The directions left, right, front, and rear, as mentioned
throughout the manual, are as seen from the tractor driver’s seat and facing forward.
POLICY STATEMENT
It is the policy of JAY
•
LOR
®
to improve its products where it is possible and practical to do
so. JAY
•
LOR
®
reserves the right to make changes or improvements in design and
construction at any time, without incurring the obligation to make these changes on
previously manufactured units.
OWNER/OPERATOR’S RESPONSIBILITY
It is the Owner/Operator’s responsibility to read the Operator’s Manual, to operate, lubricate,
maintain, and store the product in accordance with all instructions and safety procedures.
Failure of the operator to read the Operator’s Manual is a misuse of this equipment.
Like all mechanical products, JAY
•
LOR
®
products will require cleaning and upkeep. It is the
Owner/Operator’s responsibility to inspect the product and to have any part(s) and/or
assemblies repaired or replaced when continued operation would cause damage or
excessive wear to other components or cause a safety hazard.
It is the Owner/Operator’s responsibility to deliver the product to the authorized JAY
•
LOR
®
Dealer or Distributor, from whom it was purchased, for service or replacement of defective
parts which are covered by warranty. Repairs to be submitted for warranty consideration
must be made within thirty (30) days of failure. It is the Owner/Operator’s responsibility for
any cost incurred by the Dealer for travelling to or hauling of the product for the purpose of
performing a warranty obligation or inspection.
