JAY
•
LOR
Operator’s Manual
- 40 -
Trailer Units - Model 2425
7. Entangled Material:
Twine, string, and wrapping material that is not removed from bales can get tangled in
the auger or under the auger. If this material is not removed from under the auger, it can
damage seals and/or other components on the planetary gearbox, which is located
underneath the auger center post. Always remove this material as soon as it is noticed.
Important:
Always place controls in neutral, stop engine, set park brake, remove ignition
key and wait for all moving parts to stop before removing material. Failure to
follow these safety precautions can result in serious injury or death.
Operating Hints
1. Place the light, fluffy and least dense ingredients into the machine first. In that way, the
heavier and denser material added later will push the light material into the auger.
Always place hay (round, square, or loose) into the machine first.
2. Shake the bucket on the loader to control the amount of material being added to the
machine. Watch the weight indicator to know exactly how much of each ingredient you
are adding.
3. Operate the auger for 3 to 5 minutes after the last ingredient has been added and before
unloading to ensure a uniform mixture. Mixing times will vary depending on the type of
ingredients being mixed. Visually monitor the mixture to ensure that mixing is complete.
4. Consult with a feed nutritionist to determine the best combination of ingredients for your
requirements. Following their recommendations will ensure the best results with your
total mixed ration (TMR). This translates into maximum efficiency of your JAY
•
LOR
Cutter-Mixer-Feeder investment.
