JAY
•
LOR
Operator’s Manual
- 25 -
Trailer Units - Model 2425
On the bottom of the indicator are 4 outlets for attaching 4 weighbar cords. These should
not be confused with the power supply, which will not attach in the same outlet. The
weighbar cords are pushed in, and then the tightening ring threaded into place. Make sure
that the plugs are free of moisture or other contaminants as this will affect the performance
of the weighing system.
On standard models, the power cord is to be plugged into the tractor female receptacle,
which should be mounted on your tractor, getting its power supply from the tractor’s
electrical system. This should be a 12-volt negative ground power supply.
For machines using a self-contained battery, the female receptacle is connected directly to
the battery.
Important:
To avoid injury or death, always to all safety and operational instructions and
constraints pertaining to the battery, to avoid injury or death.
Some models may be equipped with a second indicator, referred to as the Remote Indicator.
This indicator is usually adjusted such that viewing from the loading equipment is permitted.
In most cases the remote indicator does not allow full access to weigh system parameters.
These are usually controlled from the main indicator as described earlier. The remote
indicator attaches to the main indicator via a cable. Like all of the other connections, ensure
that the plugs are free from any moisture and other contaminants as this will affect the
performance of the weighing system.
Note:
The scale will be programmed to display weight in either kilograms (kg) or pounds
(lbs.). This is set by the manufacturer and must be ordered to suit. If your scale is
not programmed to your preferred units of measurement, please contact your local
JAY
•
LOR
Dealer.
Note:
For complete information on Scale Operation and Settings, see the attached
Weigh-tronix
Users Manual.
