Doc ref. :
332190D –
EN
28.04.2014
Page 28 / 49
5.7.3 Reading the working frequency.
• Pick up the handle, leaving the trigger in the released
position.
• Simultaneously press buttons B1 and B2
The radio channel programmed is displayed
• Press
EXIT
(B2) to exit.
Note :
The receiver working frequency is not accessible.
5.7.4 Changing the working frequency
•
Switch on the receiver RSRB
•
Pick up the handle, leaving the trigger in the
released position (1).
•
Simultaneously press buttons B1 and B2
The programmed radio channel is displayed
•
Press the – (B3) or + (B4) button to go to the
desired radio channel.
Note :
If the handle is locked against installation
configuration changes, see §3.3.
•
Validate the new working frequency by pressing
OK*
(B1)
.
- Either for 1 second = fast mode
(to be used only if the receiver and enabling
handle were set on the same frequency)
- Or, for 3 seconds = long scan mode.
(to be used if receiver and handle can be set
on different frequencies)
The word SCAN is displayed on the
screen
•
Release the
OK
button (B1)
•
Hold the trigger in the activated position until you
get the indication to release it.
(In long scan mode, the channel Nos., C01 to
C64 scroll on the display for around 30
seconds).
*Note :
Only the channels authorised in accordance with the handle model can be used.
(1) released
(2) activated
(3) clenched
3-position trigger
(1) released
(2) activated
(3) clenched
3-position trigger
(1) released
(2) activated
2-position trigger
(1) released
(2) activated
2-position trigger
