10
1)
‘SPEED’ DISPLAY
This display area could show the speed of running belt when the treadmill is in operation, ranging from
1~8 km/h, and the number signal of a countdown from 3 to 1 when the running is starting.
2)
‘TIME’ DISPLAY
This display area could show forward timing (from 0:00 to 99:59) which will be reset at 99:59 and the
countdown from the set time to zero. Then the treadmill will smoothly stop when the countdown is
finished, and transfers to standby.
3)
‘DIS.’ DISPLAY
This display area could show the running distance which will be counted forward from 0.0 to 99.9 and be
reset when it’s over 99.9. The distance countdown will start at the set distance and descends to zero.
Then the treadmill will smoothly stop when the countdown is finished, and transfers to standby.
4)
‘CAL’ DISPLAY
This display area could show the calories consumed, forward from 000 to 990 and countdown from the
set number to zero. The number will be reset if it’s over 990. When the countdown is finished the treadmill
will smoothly stop when the countdown is finished, and transfers to standby.
2.
BUTTON FUNCTION
1) ‘PROG’ is the button which you could press and choose different built-in programs from P01 to P12 in
the standby state.
2) ‘MODE’ is the button which you could press and choose various modes including ‘15:00’, ‘1.0’, ‘50.0’
(‘15:00’ refers to time countdown mode; ‘1.0’ refers to running distance countdown mode; ‘50.0’ refers to
calories countdown mode).
The relevant numerical value of all countdown modes can be turned up and down. You can press
‘START’ and start your exercise with all parameters set.
3).’START’ is the key to start on the treadmill any time as long as the power is on and the safety key is
correctly sucked and gripped.
4).’STOP’ is the key to make a pause and reset the treadmill.
5).’+
、
-’ are the buttons to adjust the parameters in the standby state and adjust the speed when the
treadmill is operating.
And each press could make a difference of 0.1km on the speed. If you press the button more than 1
second, the speed would be automatically accelerated or slowed down continuously.
3.
QUICK START (MANUAL MODE)
1) Turn the power on and make sure the magnetic safety key is correctly sucked and gripped to the
security lock under the control panel.
2) Press ‘START’ and the system would begin to count down for 3 seconds with prompt sounds.
Meanwhile the ‘SPEED’ DISPLAY will show the countdown number and the treadmill will start on at the
speed of ‘1’ when the countdown is over.
3) ‘+’ and ‘-’ could be used to adjust the running speed during operation.
