Jaxon ES-XT30, Instruction Manual

Page: 4 / 36

3
Op
eration’s manual
Installing the propeller
Make sure the motor is disconnected from the battery before installing or replacing the prop.
Use the propeller wrench supplied or 7mm wrench for the installation. (The use of inappropriate tools may
cause motor damage).
1. Install the drive pin into the shaft hole and align it with the propeller (The drive pin and the
propeller groove must align horizontally). Once the propeller is in place install stainless washer
and nut into the shaft (picture 1).
picture 1
2. Hold the propeller to prevent it from revolving and use the propeller wrench to tighten the
propeller nut (picture 2).
picture 2
If replace or detach the propeller please follow the above instruction steps and procedure it
conversely.