4
Rev. 1.1
GETTING STARTED
The following will guide you through the installation of your J320i printer.
1.3
Printer Installation
CAUTION : Limit AC power supplied to the J320i Printer to
110 - 230 V AC, 60 - 50 Hz for an associated 680 mA - 310
mA. Limit excess current draw to 16 amps or less, using an
associated circuit breaker or other such device. Never operate
the printer in a location where operator, computer, or printer
can get wet. Personal injury could result. The printer must be
connected to an earthed electrical power supply and properly
protected against electrical surges and grounding faults.
CAUTION:
Intermittent or unpredictable operation may
occur from unsecured connectors. If damaged, the power
cable must be replaced by an exact equivalent.
Use only parallel cable under 3 metres in length.
1.
Place the printer in a location that allows easy
access to all sides. The printer should never be
operated while resting on its side or upside down.
2.
Place the printer’s power switch in the OFF
(0) position.
3.
Insert the power cable to the printer power socket
and attach to grounded electrical socket of the
proper voltage and type.
4.
Attach interface cable to printer and computer
and then secure.
5.
Switch power on.
Quick Start
Getting
Started
Operation
Starting to
Print Cards
Cleaning
Trouble
Shooting
Technical
Specifications
General
Information