Page
15
of
35
To charge the receiver internal batteries, take the following steps:
•
Plug the Receiver-to-SAE cable’s connector into the power port of the TRIUMPH-3NR.
•
Connect the opposite end of this cable with the battery charger’s SAE connector.
•
Plug the other end of this cable into an AC outlet with cable. Leave overnight.
A complete charging cycle is less than 9.5 hours.
Warning
: Risk of explosion if battery is replaced by an incorrect type. Dispose of used battery according to the
instructions.
Warning
: Before beginning to work, fully charge the battery for maximum operating time. An approximately 6-hour
charge cycle will fully charge the battery. The batteries cannot be overcharged.
Warning
: The Li-Ion batteries used in the battery packs should run at no less than 80% capacity after 500 charging
cycles. These batteries do not need to be drained before recharging.
Warning
: Never attempt to open the casing of the detachable battery! Lithium-Ion batteries can be dangerous if
mishandled!
Warning
: Do not incinerate or heat battery pack above 212° Fahrenheit (100° Celsius). Excessive heat can cause
serious damage and possible explosion.
Warning
: The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Warning
: Do not attempt to open the battery pack.
Warning
: Do not disassemble the battery pack.
Warning
: Do not charge in conditions different from specified.
Warning
: Do not use other than the specified battery charger.
Warning
: Do not short circuit the battery pack.
Warning
: Do not crush or modify the battery pack.
