12
• If you are using it in a bathroom, it is advisable to install in the
electrical circuit of the bathroom a residual differential current
device (DDR) of differential current of assigned capacity that
does not exceed 30 mA. Ask your supplier for advice.
• VERY IMPORTANT: The hair clippers, the adapter and the
base must never be immersed in water.
• It must not be used outdoors.
• If there is any nylon filament found on the blades, it’s due to the
quality control made in each unit.
• The cleaning and maintenance done by users, can not be done by
children without any supervision.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.
LUBRIFICATION
• For the hair clipper to work correctly it is absolutely necessary to lubricate the blades with oil before each
use.
• Carefully pour a few drops of oil, which is provided, between the teeth of the blade, or if you have run out, with
another high quality, acid free oil.
• Turn the hair clipper on for a few seconds and clean the excess oil off with a cloth.
CUTTING GUIDES
• The hair clipper is equipped with four cutting guides which allow for a accurate height of cut in four different
lengths (3-6-9 and 12 mm.)
• To assemble the chosen guide place it in the blade and press the bottom flange of the guide to be inserted.
BEGINNING THE CUT
• Relax and work slowly. Make short cuts. Do not go on to the final cut of one side or the back straight away. Work
gradually and all over the head.
• It is better to cut a little each time to be able to cut some more later on.
• While you are working and before you begin, comb the hair frequently to the chosen style.
• It is better to cut the hair when it is dry, not wet. It is easier to see and control the amount of hair you are cutting.
• The first time you use the appliance it is advisable to cut a small portion of hair until you get used to the different
lengths of the guides. At first use the guide which allows the longer cutting length (guide of 12 mm.). With a little
practice you will soon choose the most adequate guide for the length you wish to have.
• After combing your hair following its natural direction, proceed as follows to obtain a perfect hair cut.
First step: NAPE
• Set the guide to the position corresponding to lowest length of cut (3 mm). Start cutting at the centre of the
nape and at the bottom of the neck. Hold the hair clippers softly against the head with the teeth of the guide
pointing upwards.
• Go up gradually, working your way upwards and outwards, just cutting a little hair at a time. When cutting raise
the head of the clippers towards you little by little. Continue cutting at the back of the head from the base of
nape to the area just above the ears (Zone “A” of the figure).
