Continued set up for MIG with Gasless wire for VIPER 180 MIG ARC
(8)
Carefully feed the wire over the drive roller into the outlet guide tube, feed through about 150mm into
(9)
Align the wire into the groove of the drive roller and close down the top roller making sure the wire is
in the groove of the bottom drive roller, lock the pressure arm into place.
(1 O) Apply a light amount of pressure to the drive roller. Too much pressure will crush the cored wire.
(11) Remove the gas nozzle and contact tip from the torch neck,
(12) Press and hold the inch button to feed the wire through to the torch neck, release the inch button
when the wire exits the torch neck.
(13) Fit the correct sized contact tip and feed the wire through it, screw the contact tip into the tip holder of
the torch head and nip it up tightly.
(14)
Fit the gas nozzle to the torch head.
(15) Set the welding parameters using the wire feed and voltage control knobs.
(16) Using the Burn Back control set the amount of wire to 'burn back' after you release the torch trigger.
This prevents the wire becoming stuck in the weld pool when finishing the weld.
(8) Feed wire over the drive roller into the
outlet guide tube, Push the wire through
approx 6
"
. Use a Knurled Drive Roller of
the correct size
NOTE:
MIG 180 not geared
(11) Remove the gas nozzle and contact tip
from the front end of the mig torch.
(14) Fit the gas nozzle to the torch head.
(9) Close down the top roller bracket and clip the
pressure arm into place.
NOTE:
MIG 180 is not geared
(12) Press and hold the inch wire button to
feed the wire down the torch cable through
to the torch head.
(15) Set welding parameters using the
voltage and wire feed controls.
(1 OJ Apply a medium amount of
pressure to the drive roller
NOTE:
MIG 180 is not geared
(13) Fit the correct size contact tip over the
wire and fasten tightly into the tip holder.
(16) Adjust the burn back control to
prevent the wire sticking in the
weld pool.
17
