Installation
5
Unpacking
Check the packaging for any signs of damage.
Carefully remove the machine and retain the packaging until
the installation is complete.
Location
The machine should be located in a suitable position and
environment. Care should be taken to avoid moisture, dust,
steam, oil or corrosive gases
Place on a secure level surface and ensure that there is
adequate clearance around the machine to ensure natural
airflow.
Input connection
Before connecting the machine you should ensure that the
correct supply is available. Details of the machine
requirements can be found on the data plate of the machine
or in the technical parameters shown in the manual.
The equipment should be connected by a suitably qualified
competent person. Always ensure the equipment has a
proper grounding.
Never connect the machine to the mains supply with the
panels removed.
Output connections
Electrode polarity
In general when using manual arc welding electrodes the
electrode holder is connected the the positive terminal and
the work return to the negative terminal. Always consult the
electrode manufacturer’s data sheet if you have any doubts.
When using the machine for TIG welding the TIG torch
should be connected to the negative terminal and the work
return to the positive terminal
MMA welding
Insert the cable
plug with electrode
holder into the “+”
socket on the front
p a n e l o f t h e
welding machine,
a n d t i g h t e n i t
clockwise.
Insert the cable
plug of the work
return lead into the
“-”ve socket on the
front panel of the
welding machine,
a n d t i g h t e n i t
clockwise
TIG Welding
Insert the cable plug with the work clamp into the “+” socket
on the front panel of the welding machine, and tighten it
clockwise.
I n s e r t t h e
cables plug
o f t h e T I G
torch into the
“-” socket on
t h e f r o n t
panel of the
machine and
t i g h t e n
clockwise.
Connect the
gas hose to
the regulator /
fl o w m e t e r
l o c a t e d o n
the shield gas
cylinder and
connect the
other end to
the machine.
8
Summary of Contents for TIG 200 Dual Voltage
Page 14: ...Electrical schematic 7 13...
Page 15: ...Parts list 8 14...
