Jasic MIG160PFC, Manual

Page: 29 / 70

Page 29
spool torch.
1) If the indicator is on, it indicates that the MIG is in push torch state.
2) If the indicator is on, it indicates that the MIG is in spool torch state.
h. Selection of remote control function
Wired remote controller
1) Enter the Welding Engineer Mode (see section 6.4 for details), set the "F09" parameter to
"1", save the settings and exit the mode.
2) Before welding, press the remote control function key to enable/disable the remote
control function.
3) If the indicator is on, it indicates that the remote control function has been enabled. If it
is off, it indicates that the remote control function has been disabled.
Wireless remote controller
1) Set the remote control mode to wireless remote controller
Enter the Welding Engineer Mode (see section 6.4 for details), set the "F09" parameter value
to "0", save the settings and exit the mode.
2) Wireless pairing connection
When not welding, press and hold the panel remote control function button and the
pairing button of the wireless remote control at the same time, to pair the wireless
remote controller in 2 seconds. During pairing, the blue indicator of the wireless receiver
module will flash. After successful pairing, the remote control mode indicator will be on,
and the blue indicator on wireless receiver module will remain on and the welder display
window will display "OK".
After successful pairing, the parameters can be adjusted by the wireless remote controller.
3) Disconnecting the wireless connection
After the remote controller has been successfully paired, press and hold the remote control
function key on the panel or the pairing key on the wireless remote controller for
2 seconds, and the wireless connection of the remote controller will be disconnected. After
disconnecting, the display window of the welder will display "FAL", and the green indicator
of the wireless receiver module will remain on.
Note: The icon of the pairing key may be different from the actual one due to different