Page 24
5.5. Lift TIG welding torch and earth cable connection
(Wiring diagram of Lift TIG: DCEN)
1) Ensure that the power switch is turned off.
2) Insert the torch plug into the central socket on the front panel of the welder and tighten it
clockwise.
3) Insert the cable plug with earth clamp into the positive polarity socket on the front panel of
the welder and tighten it clockwise.
4) Insert the polarity changeover connector into the negative polarity socket on the front panel
of the welder and tighten it clockwise.
Note!
The positive and negative polarities should not be reversed as this will prevent
normal welding operation.
5) Connect one end of the gas hose to the gas valve inlet on the rear panel of the welder, and
the other end to the gas regulator outlet, and secure it with a clamp.
NOTE!
If you want to use long secondary cables (TIG torch cable and earth cable), you
must ensure that the cross-sectional area of the cable is increased appropriately in
order to reduce the voltage drop due to the cable length.
Junction box
Grounding
Power cord
Summary of Contents for MIG160PFC
