Jasic MIG 250C, Operator'S Manual

Page: 28 / 50

28
SPOOL GUN OPERATION
Before starting any welding activity ensure that you have suitable eye protection and
protective clothing. Also take the necessary steps to protect any persons within the welding
area.
Spool Gun Welding Mode
The Jasic MIG 202C, 250C and 352C can be used with our optional spool gun part number TSP - 250 - 6
which is a Euro style spool gun which will connect to the machine via the Euro outlet connector.
Connect the spool gun euro plug to the (MIG) euro socket.
Connect the spool gun 9 pin control plug to its matching 9 pin socket located on
the front panel of the machine.
Ensure the trailing lead is connected into the “+” socket on the front panel of the
machine and tighten clockwise.
Insert the cable plug for the work clamp into the “ - ” socket on the front panel of the welding machine and
tighten clockwise.
Connect the gas hose to the regulator/flowmeter located on the shield gas cylinder and connect the other
end to the machine.
Before starting any welding activity ensure that you have suitable eye protection and protective clothing.
Also take the necessary steps to protect any persons within the area.
After connecting the welding leads as detailed above you will need to switch the power switch on the
back panel to
“ ON ”. Select MIG by switching to MIG on the MMA/MIG welding mode switch and
selecting spool gun via the standard/spool gun selector switch.
Set the voltage and wire feed speed on the machine suitable for the application and wire size being used.
Ensure you have adequate welding current according to the thickness of the work and weld prep being
carried out.
Fit your 1Kg reel of welding wire to the spool holder and feed the wire through the drive rolls ensuring the
fitted roller sizes matches your wire type and size, then continue to feed the wire through the contact tip
again ensuring you have the correct size tip fitted.
Open the gas valve of the cylinder, press the torch trigger and adjust the gas regulator to obtain the
desired flow rate.
Adjust the “ voltage control knob ” and “ wire feed speed control knob ” on the front panel of the machine
to set the correct welding voltage and welding current.
Operate the torch trigger and welding can now be carried out.