Input watt, Max. Location Use
Wet
Model No.
66898
66899
12W
24W
IMPORTANT — PLEASE READ:
Refer to the manual or visit www.byjasco.com for limitations and restrictions
on warranties and the product registration information.
WARNING:
When using outdoors use portable luminaires, basic safety
precautions should always be followed to reduce the risk of fire, electrical
shock, and personal injury, including the following:
a) Ground Fault Circuit Interrupter (GFCI) protection is to be provided
on the circuit(s) or outlet(s) to be used for the wet location portable
luminaire. Receptacles are available having built-in GFCI protection and
are able to be used for this measure of safety.
b) Use only with an extension cord for outdoor use, such as an extension
cord of cord type SEW, SEOW, SEOOW, SOW, SOOW, STW, STOW,
STOOW, SJEW, SJEOW, SJEOOW, SJW, SJOW, SJOOW, SJTW, SJTOW,
or SJTOOW.
WARNING:
Keep these bags away from babies and children. Do not use
in cribs, beds, carriages, or playpens. The thin film may cling to nose and
mouth and prevent breathing.
NOTE:
Ensure the Café Light’s receptacle cover is firmly installed and well
seated when not being used to connect additional strings.
WARRANTY INFORMATION:
This Jasco product is warrantied for three
(3) years with a limited-lifetime replacement warranty on JascoPro
LED light source only. This product is intended (and/or designed) for
horizontal hanging. Vertical hanging of the product can void the
product warranty.
MADE IN CHINA
Distributed by Jasco Products Company LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a 3-year limited warranty.
Visit www.byjasco.com for warranty details.
Questions? Contact our U.S.-based Consumer Care at
1-800-654-8483 between 7AM–8PM, M-F, Central Time.
Pat.: US D837,420 and D783,186
Electrical Ratings
Input: 120V, 50/60 Hz
RISK OF ELECTRIC SHOCK
• RECEPTACLE OUTLETS USED FOR POWERING
CAFÉ LIGHTS SHALL COMPLY WITH ALL NATIONAL
AND LOCAL ELECTRICAL CODES. CONSULT
LOCAL ELECTRICIAN IF UNSURE OF COMPLIANCE
REQUIREMENTS.
• FOR USE ONLY ON GFCI PROTECTED CIRCUITS.
• DO NOT SUBMERSE.
• DO NOT USE AROUND AQUARIUMS.
• CAFÉ LIGHTS ARE A WET LOCATION PRODUCT AND
HAVE NO SERVICEABLE PARTS.
• DO NOT USE WITH EXTENSION CORD NEAR WATER
OR WHERE WATER MAY ACCUMULATE.
• KEEP LAMPS AT LEAST 16 FEET FROM POOLS AND
SPAS.
• KEEP PLUGS AND RECEPTACLES DRY.
• AVOID DAMAGE TO THE CORDS AND LAMP
ASSEMBLIES DURING INSTALLATION. PERIODICALLY
INSPECT THE CAFÉ LIGHTS FOR PHYSICAL DAMAGE
OR OTHER DAMAGE CAUSED BY OUTDOOR
EXPOSURE TO THE ELEMENTS.
• REPLACE ANY DAMAGED CAFÉ LIGHT STRINGS.
• DO NOT INSTALL IN LOCATIONS WHERE CAFÉ
LIGHTS CAN BE STEPPED ON.
• ENSURE CAFÉ LIGHTS ARE UNPLUGGED FROM
POWER DURING INSTALLATION.
• CAFÉ LIGHTS SHOULD BE INSTALLED OUT OF THE
REACH OF CHILDREN OR NOT ALLOWING CHILDREN
TO PLAY WITH THEM.
• UL RECOMMENDS TESTING GFCI CIRCUITS AND
RECEPTACLES EVERY MONTH TO ENSURE PROPER
OPERATION.
• DO NOT OPERATE WITHOUT BULB SECURELY
SCREWED IN.
RISK OF FIRE
• CAFE LIGHTS ARE DESIGNED TO BE
MOUNTED WITH THEIR INDIVIDUAL
KEYHOLE MOUNTING FEATURE, DO NOT
MOUNT CAFÉ LIGHTS BY USING THE MAIN
ELECTRICAL CORD OR THE INDIVIDUAL
DROP CORDS.
• CAFÉ LIGHTS ARE DESIGNED TO BE
LINKED BY USING THEIR ELECTRICAL
PLUGS AND RECEPTACLES TO A
MAXIMUM DISTANCE OF 750 FEET.
• CAFÉ LIGHT INTERCONNECTING
RECEPTACLES ARE INTENDED ONLY
FOR THE LINKING OF COMPATIBLE CAFÉ
LIGHT STRINGS. DO NOT USE CAFÉ
LIGHT RECEPTACLES FOR ANY OTHER
ELECTRICAL PURPOSE.
• DO NOT MOUNT CAFÉ LIGHTS IN ANY
POSITION WHERE THE BULB IS FACING
UP.
• DO NOT ALLOW THE LED LAMP
ASSEMBLIES TO BE IN CONTACT WITH
COMBUSTIBLE MATERIALS. LED LAMP
ASSEMBLIES SHOULD HANG FREELY AND
NOT BE SUSCEPTIBLE TO REPETITIVE
DAMAGE CAUSED BY ENVIRONMENTAL
CONDITIONS SUCH AS WIND, RAIN, AND
ICE.
• NOT INTENDED FOR INSTALLATION IN
CEILINGS, SOFFITS, CABINETS, ATTICS, OR
OTHER ENCLOSED SPACES.
WARNING
• BATTERIES MAY LEAK HARMFUL LIQUIDS OR IGNITABLE MATERIALS
OR EXPLODE CAUSING INJURY AND PRODUCT DAMAGE.
• DO NOT MIX OLD AND NEW OR OTHER BATTERY TYPES.
• REPLACE ALL BATTERIES AT THE SAME TIME.
• REPLACE EXHAUSTED BATTERIES IMMEDIATELY.
• REMOVE BATTERIES IF PRODUCT IS TO BE UNUSED FOR EXTENDED
PERIODS OF TIME.
CAUTION
vintage cafÉ lights
INSTALLATION
Step 1: Select mounting hardware
Choose from screws, nails, zip ties or
hooks (not included) to hang each
bulb from their keyhole tab.
Step 2: Mark bulb locations
Starting from GFCI power outlet, hold
up bulbs one by one to mounting
surface and mark location where
each will be installed — use keyhole
tabs for guidance.
NOTE:
There is 2ft. of space
between each bulb.
Step 3: Install mounting hardware
Install chosen mounting hardware
(screws, nails, hooks) on each marking.
Step 4: Hang bulbs
Carefully hang each bulb on installed
mounting hardware.
Step 5: Plug in lights
With everything properly installed,
place rubber cap over end of
female receptacle at end of café
light strand, then plug male
receptacle into GFCI outlet.
READ IT
OR
WATCH IT
Read instructions or watch easy-to-follow video.
Scan QR code or visit https://byjasco.com/54723i
IMPORTANT:
Before installing, please read through the entire manual and all safety instructions.
SETUP
• Carefully unpack café lights from box and remove wire ties.
• Plug lights into a GFCI outlet to ensure all bulbs work properly —
unplug when done.
NOTE: Use only a Ground Fault Circuit Interrupter (GFCI) receptacle
when installing outdoors.
• Choose mounting location and plan out installation. Attach only to
solid support structures such as joists, beams, studs or other solid
mounting surfaces. Guide wires in compliance with local electrical
codes may also be used.
LINKING ADDITIONAL CAFÉ LIGHTS
Each set of café lights can be linked together to form a continuous string
up to 750ft. Plug additional sets together end-to-end and follow the steps
above for a safe installation.
UNINSTALLING
Unplug from GFCI outlet, carefully remove each bulb from mounting
hardware and store café lights in a dry location.
66898, 66899 v2
3/22
FCC STATEMENT:
Suppliers Declaration of Conformity | Model #: 66898 and 66899 |
Jasco Products Co., 10 E. Memorial Rd, Oklahoma City, OK 73114,
www.byjasco.com
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC NOTE: The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
awhich the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
