C. Instruction Procedures
1
Set current time: press / to set the current time
2
Plug the receiver into the socket, turns on / off button to control receiver’s power status, LED
indicator on the receiver shows on/off status.
3
Press different function button to set your preferred on/off setting time, LED indicator turns on
to show the program you selected:
a.
my on time: set your ideal ON time
b.
my off time: set your ideal Off time
c.
evening 5pm – 12am: appliance turns on at 5pm and off at 12am daily
d.
morning 5am – 8am: appliance turns on at 5am and off at 8am daily
e.
all night 6pm – 6am: appliance turns on at 6pm and off at 6am daily
f.
countdown: set your countdown time (default 1hour)
4
Press either on, off
，
countdown button to override other program setting, eg.
a.
In countdown mode, press ON to change receiver from countdown to always ON
b.
In countdown mode, press OFF to change receiver from countdown to always OFF
c.
In evening, morning , allnight orcountdown mode, press On or OFF to switch receiver’s
power on/off status until it reaches the next program on/off status
d.
In evening, morning or allnightmode, press countdownto entre countdown mode at
once, receiver’s power on until countdown completed, the receiver will resume the
evening, morning or allnight program.
e.
evening, morning or allnight can be selected multiply.
Noted:
If the LCD display is not clear, or function is not working properly, please change the battery and try
again
D.
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Prudence
：
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement
.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
