100
Setting of the
upper
end point
.
1. Press the
UP
button on your transmitter.
2. Raise the roller shutter until the desired end point is reached.
ATTENTION! The roller shutter locking bar (end bar) must still be visible
from the outside.
3. Stop the motor at the desired position using the
STOP
button.
4. Correct the upper end point with the UP/DOWN and STOP buttons if necessary.
5. Press the
UP and DOWN
buttons on the transmitter at the same time
6. Then press the
STOP
button
2x
.
7. Press the
UP
button
briefly within 10 seconds
.
The motor will confirm the setting of the upper end point by vibrating briefly.
UP
STOP
UP and
DOWN
2 x STOP
UP
Let the roller shutter roll up and down completely several times as a test.
If the roller shutter stops at the set end points, the limit switch setting is complete
and the roller shutter casing can be closed.
To change the end points, please start from the beginning.
Always set both end points at a time!
Please note that the motor is equipped with a thermal protection
switch and it is possible that the motor will switch off automatically for
safety reasons if it reaches a high temperature after a few operations.
After a cooling period of approx. 15-20 minutes, the motor will be ready
for use again.
EINSTELLUNGEN
SETTINGS / PARAMÈTRES / AJUSTES / IMPOSTAZIONI / INSTELLINGEN /
USTAWIENIA / AYARLAR
