25
ESC+SP+n: Sets the character to n-dot line.
HEX:1B + 20 + n
DEC:27 + 32 + n
Sets the character spacing on the right side to n dot.
0
≦
n
≦
127DEC
・
The character spacing on the left side is set to 0 dot.
・
The default value: HTPN9050=4dots
ESC+”U”+n: Select inverse print
HEX: 1B+55+n
DEC: 27+85+n
Set or cancel the inverse print mode by line.
n=0: Cancel ( default value )
n=1: Set
・
If the command is set at the beginning of a line, it’s effective from that line. But
if it’s set in a line, it’s effective from the next line.
・
This command doesn’t operate for bit image and ruler line.
FS+”J”: Set 90deg. Turned Kanji characters
HEX: 1C+4A
DEC: 27+74
Turns characters 90deg. to the left.
FS+”K”: Cancel 90deg. right turned Kanji characters
HEX: 1C+49
DEC: 27+73
Turns characters 90deg. to the right.
ESC+”C”+NUL+n1+n2: Set the length of the page
HEX:1Bh + 43H + 0 + n1 + n2
DEC:27 + 67 + 0 + n1 + n2
Select the line number with n1 ( lower byte ) + n2 ( upper byte )
0
≦
n1n2
≦
4095 ( Set the length of a page )
The position when this code had input would be the top position of the page.
Please use with FF ( Set cutting operation )
